30m Perforated Layflat Irrigation Hose
This 30m perforated layflat irrigation hose with fittings gives a fine, uniform irrigation pattern without the need for complex, costly irrigation systems.
Laser technology is used to create very small, precisely sized perforations spaced evenly along the hose. When the water is turned on, the hose gradually inflates and the pressure equalises along the whole length in use, so every jet leaves the hose at the same velocity for even watering. For best results, use it on a flat surface.
Key Features
- Simple to use
- Cost-effective irrigation system
- Operates under low water pressure
- Reduces run-off
- Needs very little maintenance
- Even, uniform irrigation
- Laser-cut, evenly spaced perforations
- Hose can be cut to suit your requirements
- Fittings included
How to Use
- Connect the hose using the connections and hose clips.
- Blank off one end.
- Lay the hose out and start irrigating.
Note: turn the water supply on gradually to avoid a 'surge pressure' as the hose fills. Use the supply tap to limit the volume of water reaching the perforated hose. Lay on a flat surface for best results.
Specifications
| Length | 30m |
|---|---|
| Hose | Can be cut to suit requirements |
| Coverage | 120 m² |
| Water Application Rate | Equivalent to 4 mm of rain per hour |
What's Included
| Fitting | Quantity | Use |
|---|---|---|
| 1in Brass Hose Tail | 2 | Each end of the perforated hose |
| 1in Hose Clip | 2 | To secure the brass hose tails above |
| Blanking Cap | 1 | End of the perforated hose |
| ½in Brass Hose Tail | 1 | End of the hose |
| ½in Hose Clip | 1 | To secure the brass hose tail above |
Notes
*If your hose is larger than ½in you will need a brass hose tail to suit.
